Serving you - our customers - with the best possible service is always the primary motivation of all our employees. Therefore, quality control becomes the primary consideration and the focus of action. With rich experience in steel mesh production, each processing procedure has been strictly inspected.

No.	Test Items	Details
1	Machine Inspection	Make sure all machines are in good condition prior to production.
2	Wire Condition Check	Use a micro-caliper to check the wire diameter to ensure that the wire diameter is within tolerance and that the surface of the wire is evenly galvanized with no obvious scratches or cuts.
3	Straightening and Cut Line Inspection	Surface condition is inspected every 500 pieces, defective ones are discarded.
4	Trial Production Inspection	Adjust the welding machine mesh pulling device, current, welding pressure, warp and weft spacing, and then produce 3-5 sheets, check the sheet size, flatness, diagonal tolerance, and welding strength. If the plate is not good, re-adjust the relevant parameters. If there is no problem, then start mass production.
5	Mass Production Inspection	Check the first 5 sheets, then every 50 sheets. 1 worker randomly checks the mesh condition during welding for consistent quality control.
6	Final Inspection	Plate size, line spacing, diagonal line, welding strength, overhang size detection
7	Packaging Inspection	When everything is in place, wrap the mesh and wait for it to be shipped.